M O N T A G E I N S T R U C T I E C E N T U R Y - P A G I N A 1
A S S E M B L Y I N S T R U C T I O N S S U N L A K E - O V A L - P A G E 1 7
STANDARD SKIMMER
MODELS 5-2091-015
INSTALLATION INSTRUCTIONS
PREPARATION OF THE POOL
The pool should be built up the correct way based
on the pool assembly and installation instructions.
Approximately 70 cm water should press against the
metal wall, so that there isn’t any elasticity anymore
against the liner, before the skimmer is installed.
ATTENTION: After the skimmer hole is cut open the liner
can no longer be moved.
Skimmer installation
1. Remove all parts from the carton box. Remove the
cover of the skimmer by sliding it to the front and
then lifting is; remove the skimmer basket.
2. Fasten the skimmer valve (7) to the skimmer (3)
by using three screws (8). Push the skimmer valve
into the skimmer so that the foam side is facing the
bottom.
3. Install the top skimmer gasket (9) into the square
opening of the metal wall; make sure that the gas-
ket is positioned properly in front of the holes. Then
fasten the bottom gasket (10) into the vacuum con-
nection. Place the skimmer plate on the inside of
the pool, and keep the skimmer on the outside of
the pool. First screw tight the top angles with two
self tapping screws. Press the self tapping screws
through the skimmer plate and press the liner into
the openings of the skimmer. Lightly tighten the self
tapping screws.
Your standard skimmer facilitates the maintenance of
your pool. Leaves and floating refuse are taken out of
the water and enter into the skimmer basket. Clean the
basket regularly to continuously keep your pool clean
and hygienic. The numbers indicated between the brac-
kets refer to the numbers of the illustration (Fig 7).
Needed tools
• Crosshead screwdriver
• Screwdriver
• Stanley knife
Standard Skimmer
Cover
Inlet
Outside pool
Sand filter
Pool pump
Fig. 1
