M O N T A G E I N S T R U C T I E C E N T U R Y - P A G I N A 1
A S S E M B L Y I N S T R U C T I O N S S U N L A K E - O V A L - P A G E 1 3
STRETCH LINER
Step 16
Work in both directions with unfolding the liner and drape
it over the top rail and down the sides for about 60 cm.
The liner should be about 40 cm above the pool floor
in the center only. The bottom edge seam of the liner
should be inside the pool about 30 cm from the top rails
(see plan).
FILL POOL
Step 17
Before filling the swimming pool, hold the liner in place
by attaching two binder clips over folded cardboard on
the underside of each top rail. Because of the water
weight, the liner will be stretched with no wrinkles. Check
during filling the pool the liner for extreme tautness.
Binder clips do not self-release, so release binder clips
with extreme tautness and allow the liner to feed back
bottom liner seam
cardboard
clamp
garden hose
binder clips
into the pool until the desired tautness is achieved and
re-clamp the binder clips. Remember that you are
monitoring a minimum tightness of the liner over rail that
will control the liner seating itself against the pool floor
and up the side with no wrinkles. When the water (5 cm)
is covering the pool floor, the liner on the pool floor must
be without pleats and wrinkles.
If this occurs, pull and lift the liner wall just enough to
stretch out wrinkles or pleats by the water weight. There
should be just barely enough tension on the liner, until
the floor is filled with approximately 20 cm water and the
liner is connected against the metal wall.
The clamps can be bought at several tool shops
(Preferably use synthetic clamps).
CONTINUE FILLING POOL
Step 18
After the pool is filled, the bottom liner seam of the
liner must be totally around in the pool must be close
to crossing of the bottom wall. Do not worry about the
strength of the liner, the strength is calculated on
1,5 x the original size. When the bottom liner seam is
not on the right place, there is a chance that you have
not enough liner left to place on the top border, so that
you have to start again with placing the liner.
water level
