64
LEADING IN PRODUCTION EFFICIENCY
Operating Manual
© Dürr Systems AG
ED3K_Operating_Manual_Rev02LD_03Lug2020_EN. docx
Rev.02 – 03.07.2020
8.5.2
Cycle programs – recipe selection
Figure 38 Cycle programs – recipe selection
In this window the hydraulic and pneumatic circuits are shown in a schematic form. The scheme
can vary slightly according to the equipment installed on the machine. From this window, in recipe
mode, each cycle program (“purge”, “load”, “long purge”, “calibration A”, “calibration B” and
“calibration
C
”) can be launched separately.
At the bottom left there are two pargraphs representing the progress of the various cycle programs
for both the spray guns. Over them there is a grey rectangle in which the system status is displayed.
8.5.2.1
Cycle programs
In order to allow the operator to run a cycle program, the system must be in recipe mode.
Tap on the cycle program list, a popup window is opened. Browse the list with the up-down arrow
keys.
The last active selected cycle program raw is colorblue, the temporarily selected cycle program is
highlighted in orange. Select the cycle tapping on the check key.
