12-2020
dormakaba Canada Inc. RAC5 XT Installation Guide – PK3737 | 15
4.2.3.4 Motion Detector
1.
Refer to Annex B for detailed wiring.
2.
Mount the device at the desired location and run a 4-condutcor cable from the motion detector relay’s
terminal block to controller PCB connector J8, pins 3 & 4.
3.
To power the motion detector, connect the +12V input of the motion detector to the red wire connecting
the +DC OUT terminal on the power supply and the 12V input of the controller PCB (J16, pin 1), as shown in
Annex B. Then, connect the GND input of the motion detector to the black wire connecting the -DC OUT
terminal on the power supply and the GND input on the controller PCB (J16, pin 2). The use of wire
connectors/caps is recommended to ensure reliable electrical connections.
4.2.3.5 Fire Alarm Panel
1.
Refer to Annex B for detailed wiring.
2.
Remove the jumper wire connected between pins 3 and 4 of connector J18 on the controller PCB and
complete the fire panel installation as per manufacturer’s indications.
4.2.3.6 Tamper Switch to Premise Alarm System
1.
Disconnect the wires on controller PCB connector J7 pins 1 & 2, and run a 2-connector cable from the
switch to the premise alarm system.
The tamper alarm switch’s polarity is such that when the door is closed, the switch itself
is also in a closed state. Ensure that the wiring to the premise alarm system is done
accordingly to prevent false alarms.
4.2.4 Power Adapter Connection
NOTE:
Dependent on the countries’ electrical power requirements. Refer to Annex B for detailed wiring.
4.2.4.1 International Power Adapter
1.
Attach the appropriate AC outlet prong to the power adapter.
2.
Route the power adapter wires into the enclosure and secure the wire (recommended with tie wraps)
3.
From the inside of the enclosure, crimp the fork terminals supplied in the hardware bag to the end of each
wire.
4.
Connect the fork-terminated wires to the power supply inputs as shown in Annex A.
4.2.4.2 North America Power Adapter
1.
From the inside of the enclosure, connect one end of the fork-terminated wires to the power supply inputs
as shown in Annex A.
2.
Route the wires out of the enclosure to the AC power source and secure the wires (recommended with tie
wraps).
3.
Crimp the fork terminals supplied in the hardware bag to the end of the wires and connect them to the
power adapter screw terminals.
IMPORTANT
