12-2020
dormakaba Canada Inc. RAC5 XT Installation Guide – PK3737 | 12
a)
Determine the routing needed for all wiring of the RAC5 XT card reader and peripherals
and select the enclosure knock-out(s) to be removed for installation of the strain
relief(s)
b)
Remove the selected knock-out(s) using a hammer and screwdriver / awl, and from the
inner side of the enclosure, tap out the small metal disc
c)
Based on the amount of wires to be routed, attach the appropriate strain relief to the
enclosure as shown in Figure 7. Do not attempt to route an excessive amount of wires.
If extra strain reliefs are required, please contact dormakaba Canada Inc.
Figure 7 – Strain Relief
5.
Utilize a dip switch (SW2) to configure the system and test parameters.
•
Number of Devices switch setting (SW3)
a)
OFF
– One locking device
b)
ON
– Two locking devices
•
Test Mode switch setting (SW4)
a)
OFF
– Normal operation
b)
ON
– Test mode
4.2 Installation and Wiring Procedures
4.2.1 Mount the Enclosure
Install the enclosure in the desired location using the appropriate items from the hardware bag.
NOTE:
For easier access, we recommend removing the access door prior to installation
Figure 8 – Enclosure
