dormakaba USA Inc. System User Guide 7040.1121 Rev E 10/22 | 39
3.
If using a multi-lock System, select the corresponding lock number on the Keypad. Otherwise, skip to the
next step.
4.
Navigate through each Audit transaction with the Arrow buttons on the Keypad.
To view the codes defined for each audit, please refer to
To retrieve Audits from a safe lock to the LA GARD Software client, refer to
in this document. Further details concerning Audits can be found in section
3.17 “Time/Date Rules in LA GARD
3.12 Wrong Try Penalty
The Wrong Try Penalty occurs when a User inputs a credential incorrectly 4 times in a row. The penalty period is
for 5 minutes, within that time no safe lock connected to the Keypad will open. All menu access and command
inputs on the Keypad will also be locked for 5 minutes. Once the 5-minute penalty is over, 2 consecutive
incorrect credential inputs will initiate another 5-minute penalty. The Wrong Try Penalty does not expire. This
penalty cycle will not be cleared until the lock is successfully opened.
For Display Keypads, 2 short low beeps and 2 short red flashes will repeat every 10 seconds to signify the
penalty is in effect. The time will count down on the screen. During this penalty the Keypad will respond to any
key with 2 short low beeps and 2 red flashes. When the Wrong Try Penalty is over, the LED will flash green
twice and the keypad will produce 2 high beeps.
For Non-Display Keypads, 2 short low beeps and 2 short red flashes will repeat every 10 seconds to signify the
penalty is in effect. During the penalty, the Keypad will respond to any key press with a short low beep. When
the Wrong Try Penalty is over, the LED will flash green twice and the keypad will produce 2 high beeps.
Note:
If power to the Keypad is interrupted and restored during a Wrong Try Penalty, the penalty period will
resume with same time remaining.
3.13 Locks
Certain functions and commands can be carried out on the Keypad without the use of software. Keypads
without a display screen can only have one safe lock installed at a time; they do not support a multi-lock setup.
3.13.1 Physical Installation of a Lock
The process of physically installing a safe lock differs with single and multi-lock systems. For information and
steps on how to physically install a safe lock(s) to a system, whether single or multi-lock setup, refer to the Safe
Lock Installation Guide (Document #7034.1121).
3.13.2 Uninstall (Electronically Un-pair) a Lock
3.13.2.1 Uninstall a Lock – Display Keypad
Follow these steps to Uninstall a safe lock on a Display Keypad:
1.
Enter an Authorized User ID and Combination.
2.
Navigate through the Main Menu and select “System”.
3.
Select “Locks” from the sub-menu.
4.
Select “Uninstall”.
