DOMUSA TEKNIK DUAL CLIMA R, Инструкция по установке и эксплуатации

Страница: 5 / 84

5 DUAL CLIMA R
1 SAFETY WARNINGS
1.1 Usage and installation warnings
DUAL CLIMA R heat pump must be installed by personnel authorised by the Ministry of Industry, in
compliance with the applicable laws and regulations. The precautions detailed here cover very
important issues. Please be sure to follow them carefully.
Read carefully this instruction manual and keep it in a safe, easily-accessible place. DOMUSA TEKNIK
will not be liable for any damages caused by failure to follow these instructions.
This heat pump is suitable for use in both heating and cooling installations and can be combined with
fan coils, underfloor heating/cooling, low-temperature radiators, and domestic hot water tanks
(optional). It must be connected to a heating/cooling installation and/or a domestic hot water
distribution network and compatible with its performance and power.
This appliance must only be used for the purpose for which it has been expressly designed. Any other
use is considered unsuitable and therefore hazardous. The manufacturer shall not be considered liable
under any circumstances for damage caused by unsuitable, erroneous or irrational use.
Remove all the packaging and check the contents are complete. In case of doubt, do not use the heat
pump. Contact your supplier. Keep the packaging elements out of reach of children, as they can be
dangerous.
Improper installation or placement of equipment or accessories may cause electrocution, short circuit,
leakage, fire, or other damage to the equipment. Use only accessories or optional equipment
manufactured by
DOMUSA TEKNIK and designed specifically to work with the products presented in
this manual. Do not modify, replace or disconnect any safety or control device without first consulting
the manufacturer or the Official Technical Assistance Service of
DOMUSA TEKNIK .
When it is decided not to use any more the heat pump, disable the parts that could represent a potential
hazard.
1.2 Personal safety warnings
Always wear appropriate personal protective equipment (gloves, safety goggles, etc.) when performing
installation and/or maintenance on the unit.
Do not touch any switch with wet fingers. Touching a switch with wet fingers may cause electric shock.
Before accessing the electrical components of the heat pump, disconnect the main power supply
completely.
Disconnect all electricity sources before dismantling the cover panel from the electric panel or before
making any connections or accessing electrical parts.
To avoid electrocutions, be sure to turn off the power for 1 minute (or more) before servicing the
electrical parts. Even after 1 minute, always measure the voltage at the terminals of the main circuit
capacitors and other electrical parts before touching them and make sure that the voltage is equal to
or less than 50 Vdc.
When the cover panels are disassembled, the energised parts can be easily accessed. Never leave the
unit unattended during installation or during maintenance work when the cover panel is removed.
Do not touch the coolant pipes, water piping, or internal parts during and immediately after operation.
Pipes and internal parts may be excessively hot or cold, depending on the use of the unit.