DOMUSA TEKNIK DUAL CLIMA R, Инструкция по установке и эксплуатации

Страница: 10 / 84

EN
10 DUAL CLIMA R
4 OPERATION
4.1 Operating mode manual selection
Depending on the set-up of your installation, the DUAL CLIMA R heat pump will be able to manage
up to 5 different operating modes manually. To select these operating modes, press MODE ( 3 ) from
the home screen and the following modes will be displayed:
+ Heating and DHW mode
Heating Mode.
Domestic Hot Water (DHW) Mode.
+ Cooling and DHW mode
Cooling Mode.
When the heat pump is set and installed for its functioning in "AUTO" mode, the Heating and Cooling
modes are not available to be selected manually. The heat pump enables and disables automatically
these modes by means of the signal received from a remote room thermostat connected (see
"Heating/Cooling "AUTO" mode functioning"
).
Depending on the configuration of your installation, some of the operating modes listed may not be
selectable. Please read carefully the following sections, which describe in detail the operation of these
modes.
4.2 Cooling mode
This mode is selectable only if the heating/cooling installation is ready for operation in Cooling mode
(cooling floor, fan coils, etc.) and the heat pump is configured for this purpose.
In this operating mode, the DUAL CLIMA R heat pump will cool and keep the water in the
heating/cooling installation at the desired temperature. To do this, select the desired cooling
temperature setpoint (see
"Temperature Selection"
) and the temperature of the room thermostat (if
any) (see
"Operation in Heating/Cooling "AUTO" mode"
).
This mode will operate only on the heating/cooling installation, disabling the DHW production service,
if any.
4.3 Heating mode
In this operating mode, the DUAL CLIMA R heat pump will heat and maintain the water in the
heating/cooling installation at the desired temperature. To do this, select the desired heating
temperature setpoint (see
"Temperature Selection"
) and the temperature of the room thermostat (if
any) (see
"Operation in Heating/Cooling "AUTO" mode"
).
This mode will operate only on the heating/cooling installation, disabling the DHW production service,
if any.