Domestic CoolAir SP950I, Руководство по установке

Страница: 24 / 324

EN
Configuration of unit software CoolAir SP950I
24
You can connect the unit to the battery via the lorry's terminal block or directly.
The terminal block is to be preferred for the connection. Ask your vehicle manu-
facturer for the specifications of the terminal block.
➤
Lay the supply line and connect it to the vehicle (red line to plus, black line to
minus).
7 Configuration of unit software
Before you first start up the unit, the controls can be adapted to suit the
installation conditions. This must be done by the person installing the unit.
In configuration mode, the following unit software parameters must be set at the
control panel (fig.
b
, page 8).
I
Menu
level
Parameter Meaning
Default
setting
1 Set temperature The unit starts at the temperature
defined here. 20 °C (68 °F)
2 Low voltage
cut-off The battery monitor shuts down the unit
at the voltage defined here. Characteristic
figure 4 =
22,8 V
3 Operating mode The unit starts with the operating mode
defined here. 0 = Auto-
matic mode
4 Default settings Parameters 1 – 3 can be reset to the
default settings. --
5 Temperature unit
display The temperature can be displayed in °C
or °F. °C
NOTE
Configuration mode can still be activated if the undervoltage protection
mechanism has switched off the unit and only residual voltage is available.
SP950I--I-16s.book Seite 24 Mittwoch, 1. Februar 2017 8:14 20