Domestic CoolAir SP950I, Руководство по установке

Страница: 23 / 324

23
EN
CoolAir SP950I Installation
6.7 Connecting condenser unit to evaporator unit
I
➤
Route the long connection cable for the 24 V connection, in a curve out
through the opening in the floor of the condenser unit.
➤
Mount the remaining fastening holder (fig.
0
, page 7).
➤
Fasten the 24 V connection cable using the size 10 clamp, the M6 screw, M6
washers and the M6 lock nut to the additional fastening holder (fig.
a
,
page 8).
A
6.8 Installing the electrical supply lines
!
A
I
NOTE
The procedure for making the mechanical and electrical connection of the
evaporator unit to the condenser unit is available in the condenser unit's
installation manual.
NOTICE!
The clamp is used as a strain relief for the 24 V connection cable. The 24 V
connection cable must not slip through the clamp.
Secure the 24 V connection cable against chafing.
WARNING!
•
The electrical power supply may only be performed by qualified personnel
with specialist knowledge.
•
Make sure there is no voltage present on electrically operated components
before carrying out work on them!
NOTICE!
•
Fit a fuse of 25 A to the connection to the vehicle's power supply.
•
The battery must be able to supply the required current and voltage
(chapter “Technical data” on page 29).
NOTE
The unit is equipped as standard with a 4 m long cable with a cross-section of
8 mm
2
. If longer cable lengths are required, then the cable cross-section must
be increased by an authorised specialist workshop:
In this case, extend the cable using a 16 mm² cable. Make a professional
connection.
The 16 mm² cable must not be longer than 8 m.
SP950I--I-16s.book Seite 23 Mittwoch, 1. Februar 2017 8:14 20