Docomo F-02E Arrows X, Инструкция по эксплуатации

Страница: 88 / 208

Settings
86
◆ Wi-Fi
With Wi-Fi function of the terminal, you can use mail or access
the Internet by connecting to the home or company network or
public wireless LAN access point.
To connect to a LAN access point, you need to set connection
information.
■ Reception interference caused by Bluetooth
Wireless LAN (IEEE802.11b/g/n) and Bluetooth function use
the same frequency band (2.4GHz). If you use the wireless LAN
function and Bluetooth function of the terminal at the same
time, reception interference may occur and the
communications speed may lower. Also, you may hear noise
or have a connection problem.
Even when you use only wireless LAN function of the terminal,
the same problem may occur when someone uses a Bluetooth
device near you. In these cases, do the following.
･
Keep the terminal over 10 m away from a Bluetooth device.
･
If you use the terminal within 10 m, turn off the Bluetooth
device.
❖
Connecting to network with Wi-Fi ON
1
From the Home screen, → [Settings]
2
Set [Wi-Fi] to [ON]
3
[Wi-Fi]
→
Select a Wi-Fi network
･
When you select a Wi-Fi network protected by security,
enter a password (security key) and tap [Connect].
･
After selecting Wi-Fi network, connection selection
screen may appear.
✔
INFORMATION
･
Even when Wi-Fi is ON, packet communication is available.
However, while you connect Wi-Fi network, Wi-Fi comes first.
When the Wi-Fi network is disconnected, it switches to LTE/
3G/GSM network connection automatically. Note that packet
communication fee may apply if network connection stays
switched.
･
If you enter a wrong password (security code) when selecting
an access point to connect, [Private IP address has been
assigned. Connection is restricted.] appears. Make sure the
password (security code). If [Private IP address has been
assigned. Connection is restricted.] appears in spite of
entering correct password (security code), correct IP address
may not have been obtained. Check signal condition and
reconnect.
･
To use docomo services via Wi-Fi when you use Wi-Fi, set Wi-
Fi option password beforehand. To make settings, from the
Home screen,
→ [Settings] → [docomo service] → In [Wi-Fi
settings for docomo apps], tap [Wi-Fi option password] to
operate.
❖
Scanning Wi-Fi network
･
Set Wi-Fi to ON in advance.
1
From the Home screen,
→
[Settings]
→
[Wi-
Fi] → → [Scan]