DS-320SA
Instruction Manual
- 7 -
www.doallsaws.com
2.6
PURPOSE OF THE MACHINE
The DS-320SA sawing machine is designed:
to cut bars and shaped materials (pipes). The size of bars is defined in a table, chapter 4. Saw is
constructed for cutting of bars of maximal diameter (11,8x12,6in) in length of 236in. At longer bars
the maximal diameter decreases proportionally.
to saw steel materials, but also non-ferrous and light metals. However, we recommend consulting
the manufacturer about this option. No other materials may be sawn without approval from the
manufacturer.
for operation in a standard environment.
The machine is designed and produced to cut bar materials in agreement with the instructions described in
this manual. No other use is permitted.
Sawing is not permitted if the material is not properly gripped in the vice.
The machine is designed to saw steel materials, but also non-ferrous and light metals. However, we
recommend consulting the manufacturer about this option.
No other materials may be sawn without approval from the manufacturer.
To achieve correct operation of the machine and the safety of operators, the structural properties and size of
the saw-band may not be altered under any circumstances and all instructions printed in this manual must be
observed.
The electrical installation should be connected to 3/PE AC 230V 60Hz, TN-C (or 2 AC 24V 60Hz, PELV)
power network, see technical data in the electronic documentation.
The electrical installation of the machine should be used in an environment determined by the valid
regulations and technical standards with the following ambient effects:
AA5 (ambient temperature 40 to 105°F), AB5 (relative humidity up to 95%), AC1, AD1 (negligible presence
of water), AE1, AF1, AG2, AH2, AK1, AL1, AM
negligable effects: AN1, AP1, AQ1, AR1, AS1, BA4 (only qualified persons may operate the machine), BC3,
BD1, BE1, CA1,CB1
The saw machine does not produce excessive high-frequency electromagnetic disturbances. The machine is
expected to operate in an electromagnetic environment as defined in the valid regulations and technical
standards.
Observing the instructions and processes for installation, operation, maintenance and cleaning stated in the
following chapters of this manual, are further conditions for the use of the sawing machine.
NOTICE:
The manufacturer (supplier) bears no responsibility for any damage incurred by using the machine
for different purposes or in different circumstances. All the responsibility falls on the User.
The operator is only allowed to perform the operations described in the manual. Any interference
with the machine not covered in this manual belongs to an authorized company.
Before putting the machine into operation or when teaching a new operator, we recommend studying
the manual properly. Only in this manner will you be able to fully utilise the outstanding properties of
the sawing machine.
We recommend observing the data in the tables for choosing saw-bands. Consult all queries with our
technicians.
In order to achieve the best quality of our services, we only accept written orders (fax, e-mail, surface
mail). When ordering maintenance service, always give the name and model of the sawing machine,
year of production, serial number, name and code of the spare part. Describe the malfunction as
clearly as possible.
band saw machine DS-320SA it is a product that answers demands of technical directives.
