DS-320SA
Instruction Manual
- 55 -
www.doallsaws.com
12.7
HYDRAULICAL UPPER VICE
Hydraulic upper vice mounted on the main vice. Hydraulic upper clamping tightens the material in vertical
sense by the hydraulic cylinder connected with the cylinder of the main vice.
WARNING:
upper clamping can be used only when doing vertical cuts, there could be a
collision when doing angle cuts.
pic: 15-2
1.
Adjustable screw of firm jaw
2.
Mounting screws of basic thrust jaw
3.
Short stroke hydraulic cylinder of the upper vice
4.
Lead screw of the upper clamping
5.
Adjustable screw of movable jaw
6.
Movable jaw of the vice
7.
Firm jaw of the vice
8.
Basic thrust jaw A or B type type (A=130mm, type B=250mm)
9.
Mounting screws of replaceable thrust jaw
10.
Replaceable thrust jaw A or B type type (A=130mm, type B=250mm)
11.
Quickclamps
12.
Plugs
12.7.1
UPPER THRUST SETTING
Upper thrust is delivered with the basic jaw (
pos.8)
length L2=4,7in, two replaceable jaws
(pos.10),
length L1=9,8in.
It is necessary to set the upper thrust according to the diameter of the material. Set the upper thrust
according to the following table:
Version of composition
A
B
C
hight of the bundle
(mm)
0-2,4in
2,4-4,8 in
3,15-5,12in
use of thrust jaws
Basic jaw + replaceable
jaw A type
Basic jaw + replaceable
jaw B type
Basic jaw
Min. width of the bundle is 4,7in ( when using the 4,7in long jaw )
Max. width of the bundle is 11in ( it is possible to use the jaw of 9,8in or 4,7in length)
