Operating Instructions
DISAG RM IV
Operating Instructions DISAG RM IV Seite 9
4.
Getting started
Requirements on site:
Place the
DISAG RM IV
on a horizontal surface. Make sure that there is sufficient free
space to the front and back of the machine to ensure that the targets for evaluation are
transported flat through the machine. The targets must not be prevented from running
straight through the evaluation machine.
The ambient temperature and the air humidity must be moderate. Temperatures under 5°
C and over 40° C should be avoided both in operation and when storing the
DISAG RM IV.
Connection to mains power supply:
Connect up the evaluation machine to the mains power supply with the supplied cable.
Please observe the details (voltage, mains frequency) given on the rating plate.
The version number will be displayed for a brief period after switching on the
DISAG RM
IV
. You should always have the version number ready to hand should you have any
enquiries about the unit.
DISAG RM IV
V1.00.7 15.07.02
Setting one type of target
The required type of target to be evaluated next can be selected with the
Neu-
start
NEW-
START- key. Several standard types of targets have already been defined before putting
the machine into
operation for the first time
. Should you need to use further types of
targets these can be entered in a learn-in process at any time.
The following will be shown on the
DISAG RM IV
display:
Type123456789ABX
1 AR-Target
Twelve different types of target can be filed in the machine. The filed data is also retained
even after the machine has been switched off. Every capital X stands for a not occupied
memory slot. An used memory slot si displayed with ‘1’ –
‘9’ and ‘A’, ‘B’ and ‘C’.
A triangle flashes on the first type (the "1"). The flashing triangle is the actual entry
position. Afterwards the triangle is designated with the "cursor".
