Operating Instructions
DISAG RM IV
Operating Instructions DISAG RM IV Seite 27
LICENCE NUMBER
The licence number (which is the same as the serial number of the machine) will be shown
when this point in the menu is called up. This licence number must be known to update
software. You will receive further information when an update is made.
SERVICE MENU
Since machine specific variables can be altered in the service menu which can cause
faulty functions if not carried out professionally this section of the program is also blocked
by means of code to prevent use.
5.10 ARROW KEY FROM TOP RIGHT TO BOTTOM LEFT
The ARROW key (from top right to bottom left) enables scrolling backwards in those
sections of the program in which an arrow is shown in the display.
No. rings
10 ?
Moreover, this enables the drive motor of the drawing-in mechanism to be run backwards
so that any target that may be stuck in the evaluation shaft can be run out of the machine
again. The motor is switched off again by means of the ESC key.
Important!
The target must not be pulled or pushed by hand once it has been taken up by
the machine.
The
DISAG RM IV
is a measuring instrument and should be also treated as
such!
5.11 ARROW KEY FROM BOTTOM LEFT TO TOP RIGHT
The ARROW KEY (from bottom left to top right) makes continuous scrolling possible in
those sections of the program in which an arrow is shown in the display (see also Fig. 7).
Moreover, this enables the drive motor of the drawing-in mechanism to be run backwards
so that any target that may be stuck in the evaluation shaft can be run out of the machine
again. The motor is switched off again by means of the ESC key.
