Operating Instructions
DISAG RM IV
Operating Instructions DISAG RM IV Seite 13
Afterwards the actual set number of shots for the selected type of target will be displayed.
This can be taken over by pressing the
ENTER-key if the setting is correct.
Should another number of shots be required, a different number of shots can be selected
with the ARROW KEYS
or
.
This means that already defined types of target will be recognised automatically again
even after the
DISAG RM IV
has been switched off. A once programmed type of target will
be recognised
from the paper width
when the target is pushed into the evaluation shaft.
Always push the target in the position which has been entered in the learn-in process
when evaluating.
Attention : Starting with the software version V 1.05.4, you can switch off the
automatic target-type-detection. If you wish the manual target-selection, you can
select this in the menu ‘Typechange’
To delete one type of target:
If you should want to delete one type of target, select the type by means of the ARROW
KEYS in the NEW START menu and then press the CLEAR key.
A question will then come up on the screen and you will be asked whether you really want
to delete this type of target. Confirm this with the ENTER key. The process can be
interrupted with the ESC key without this particular type of target being deleted.
The setting sequences for a new type of target should be obvious from the program
operating sequences. However, the
DISAG RM IV
program offers considerably more
facilities. The functions of the different keys are covered in the next chapter in these
operating instructions.
