6
Axle Mounting (Right Side)
Remove the nuts and lock
washers on the right axle.
Install the axle extension and the
light pole (right side).
Install the 8 lock washers and
tighten all 8 nuts.
Lift the harvester with a forklift.
Advance the harvester to the
right side tandem and slide the
tube into the hole of the
harvester.
The axle should slide in easier
when the harvester is lifted to
approximately 18” between the
ground and the frame.
The longer portion of the axle
should be towards the rear of the
harvester.
Use the lock pin and cotter pin in
the toolbox to fix the axle to 1 of
the 3 desired position (3 holes in
the long tube).
Typically, the axle should be
installed with no holes exposed
(axle tube assembly as close to
the harvester as possible).
Approach the harvester perpendicular.
Ensure the forks do not make contact
with the kernel processor.
Longer portion of the axle towards the rear.
The tube must be
installed so that
the metal plates
face upwards.
