14
Transport Plates
Spout
DANGER: Removal of this spout bracket must be done prior to operating any of the
hydraulic systems. Failure to remove this bracket before operating the hydraulics could
result in injury or death.
In certain transport scenarios, the spout must be lowered in order to fit transport enclosures. This is achieved by
utilizing a temporary support bracket.
The spout is heavy. Support the
spout safely with a lifting strap and
use an overhead chain block or
another lifting implement to lift.
Be mindful not to pinch hydraulic
lines or wiring. Do not use a chain
to lift the spout.
Remove and retain the 4 bolts and
nuts (2 each side).
The spout may have shifted during
transport. The spout may need to
be jostled in order to remove the
bolts.
Discard the yellow curved support
bracket.
Slowly lift the spout with the lifting
implement. If it does not pivot,
loosen the remaining 2 bolts more.
Do not remove them.
While lifting, the spout pivot
should rotate and fall into place as
shown in the photo.
Once the pivot is fully seated, the
bolts and nuts can be reinstalled.
Tighten all 4 bolts and nuts (2 on
each side).
This bolt will need to be loosened
on both sides of the spout in order
for it to pivot. Do not remove it.
Remove and retain the
4 bolts and nuts. 2 from
each yellow bracket.
