5 Configurations on Web Interface
UC100-1
V
1S1O User Manual
Copyright©2011-2016 Dinstar
54
Table 5-15 Explanation of FXO Parameters
Name
The
name of this FXO profile
Tone Group
The national standard of dialing tone, busy tone and ring tone;
default value is China
Digit Timeout (s)
The timeout value for dialing a digit of a telephone number;
When the time of dialing a digit exceeds this value, the system
will think the dialing has completed; Default value is 4 seconds
Dial Timeout (s)
The timeout value for dialing the first telephone number after
off-hook; Default value is 10 seconds
Ring Timeout (s)
The timeout value for the ringing of the analog phones of the FXS
port when there are incoming calls
No Answer Timeout
(s)
The timeout value for ending a call which goes out through the
FXS port, when nobody answers the call.
Detect Polarity
Reverse
Whether to enable ‘detect polarity reverse’. If ‘detect polarity
reverse’ is on, call tolls will be calculated based on the changes in
voltage. If ‘detect polarity reverse’ is off, you need to set the time
for offhook delay and call tolls will be calculated starting from the
set time.
Detect Caller ID
Detect before ring: the CID will be shown before ringing;
otherwise, CID will be displayed after ringing;
Detect after ring: the CID will be shown after ringing; otherwise,
CID will be displayed before ringing
Off: the CID will not be shown
DTMF Detect
Timeout(s)
The timeout value to detect CID (in DTMF format)