3 Basic Operation
UC100-1
V
1S1O User Manual
Copyright©2011-2016 Dinstar
15
3. On the condition that the device is running normally, press the RST button for more than 6
seconds, and all configurations are restored to the default settings.
4. On the condition that the device is powered off, press the RST button for more than 30
seconds, the device will wipe out all configurations, rebuild a file system and then re-load a
firmware version (this method is used in case of version fault).
3.9 Query IP Address and Restore Default Setting
After connecting a telephone to the FXS port, you can dial *158 to query the IP address of
LAN port and dial *159 to query the IP address of WAN port.
If you want to restore UC100-1G1S1O to default settings, you can press the
RST
button for
more than 6 seconds or you can configure it on the Web interface.
On the Web interface, click
System
Backup/Restore/Upgrade
and then select the parts
(system, network or service) that need to be restored to default settings. Click
Reset
and then
restart the device, and the selected parts will be restored to default settings.
Figure 3-2 Reset to Defaults