Dinolift Dino 95T, Руководство по эксплуатации

Страница: 52 / 88

DINO 95T
52
14. Inspect the brakes and the driving device
–
remove the wheels
–
clean the brake system and check the settings
–
check the free movement of the brake shoes the operation of their return springs
–
replace any worn out linings
–
check the condition of the driving device and lubricate the joints
–
put the wheels in place and tighten the wheel bolts
Re-check the tightness of the wheel bolts after about 100 km drive (90 Nm).
–
check the tyre pressure: 270 kPa (2.7 bar) on the rear axle
250 kPa (2.5 bar) on the jockey wheel
–
check the free movement of the overrun brake and the parking brake
–
check the safety wires
15. Check the condition of the lights and the reflectors
16. Repeat the anti-corrosion treatment using e.g. Tectyl 210R anti-corrosion agent
17. Test-run with a load of 200 kg following the loading instructions.
Check the structures after the test-run.
18. Draw up a test protocol, save your own copy and give the other copy to the customer
19 INSPECTION INSTRUCTIONS
All lifting equipment and lifting gear used at a construction site must always be inspected before
use. The lifts and related lifting gear used on a work site shall be subjected to a regular
maintenance inspection; if possible once a week.
Keep a journal of any notable shortcomings and defects observed and advise the foreman of them.
19.1 FIRST INSPECTION
The initial inspection and test loading of the Dino access platforms is performed by the
manufacturer. A protocol which accompanies the lift is drawn up of the inspection.