Dinolift Dino 95T, Руководство по эксплуатации

Страница: 27 / 88

DINO 95T
27
IF THE SAFETY DEVICES OR THE EMERGENCY DESCENT SYSTEM ARE NOT
WORKING, HAVE THEM REPAIRED BEFORE OPERATING THE LIFT!
12. Refer to the item "Daily inspections" in the task list for servicing.
13. With the boom slightly lifted and the telescope extended, make sure that the platform
does not lower of itself while the operating controls are not being used.
14. When working under cold weather conditions, let the engine run for a while without load
to increase the hydraulic oil temperature. Start the operations by driving the movements
carefully without load back and forth from the chassis control panel.
15. Move the platform to the work object
If several control levers are operated simultaneously, only the movement with the least resistance
will operate.
NOTE!
Lowering the platform to transport position: Always retract the telescope completely before
lowering the boom onto the transport support.
DO NOT DAMAGE THE TOW-BAR JOCKEY WHEEL!
DO NOT TAKE ADDITIONAL LOAD IN THE UPPER POSITION!
16. Working a long time in the same position
- There are pushbuttons for both stopping and starting the engine on the chassis control
panel. When the weather is warm and the platform is kept for a longer period in the same
position, it is not necessary to let the engine run continuously.
-
when the weather is cold, it is recommended to let the engine run to keep the hydraulic oil
warm
-
check the stability and condition of the base regularly during the operation, taking into
account the weather and ground conditions
-
The engine is switched off if the key is turned to position 1c and starts automatically when
the speed is selected from the platform control panel using the switch 17 but stops again,
after a delay of 4 seconds, if the switch is not turned.