Digital Equipment HA3000, Руководство по установке

Страница: 39 / 96

HA3000 UPS RECEIVING AND HANDLING 3–5
3.3.5 Moving Unit to Final Position
Digital recommends that the HA3000 series cabinets be left on the rolla-lifts for moving
them to the final position.
If the trucker/mover/rigger desires, the following procedure can be used to move the
HA3000 series cabinet to the final position on the cabinet casters.
1. Ensure that the four caster lifting legs are raised enough to allow the HA3000 series
cabinet to rest on the four casters.
2. Slowly lower both rolla-lift halves simultaneously until the HA3000 series cabinet is
resting on the four casters.
3. Use a sufficient number of people to roll the HA3000 series cabinet to the installation
area.
4. Slide the plastic shipping bag off the HA3000 series cabinet.
5. Roll the HA3000 series cabinet to the final installation position.
3.3.6 Caster Removal
NOTE
All yellow caster assemblies must be removed by the trucker/mover/rigger
after final positioning. The caster assemblies are to assist only in moving the
unit from the shipping/loading area to the computer room. Proper electrical
installation cannot be accomplished unless the yellow caster assemblies have
been removed.
Digital recommends that the HA3000 series cabinets be left on the rolla-lifts for removing
the casters.
If the trucker/mover/rigger desires, the following alternate procedure can be used to
remove the casters from the HA3000 series cabinet.
1. The trucker/mover/rigger should use a 5/8-inch wrench to lower the four caster lifting
legs until they touch the floor.
2. Alternately lower each caster lifting leg one turn at a time until the four casters are
off the floor.
3. Use a 1/2-inch wrench to remove the two nuts that secure each of the four casters to
the caster rails.
4. Alternately raise each caster lifting leg one turn at a time until the HA3000 series
cabinet rests on the bottom rails.
5. Use a 3/8-inch wrench to remove the two bolts that secure each of the two caster rails
to the bottom of the unit.
6. Slide the two caster rails out from under the unit.
NOTE
The customer should keep the caster rails, casters, and all mounting hardware
at the site to be available for future equipment movement (if needed).