Digital Equipment DEClaser 320, Руководство по обслуживанию

Страница: 48 / 400

2.6 Test Menu
2.6 Test Menu
The Test menu is used to print out the configuration and font status sheets or
to enter and exit Control Representation mode.
To invoke the Test menu, first press
Online/Pause
to display PAUSE, then
press
Test
. The Test Menu is only functional when DEC PPL3 protocol is
invoked. Use
>
,
^
,
_
, and
3
to scroll and select Test menu features. The
following four selections are available from the Test menu:
Table 2–11 TEST Menu
Feature Description
CONFIG SHEET See Section 2.6.1, Configuration Sheet
Font status list See Section 2.6.2, Font Status Sheet
Start CR mode
Stop CR mode See Section 2.6.3, Control Representation (CR) Mode
2.6.1 Configuration Sheet
Figure 2–5 is an example of a DEClaser 3200 Configuration sheet. Section 2.6
describes the Test menu. The Configuration sheet lists the following
information:
• The value of each Setup feature, discussed in Section 2.4.
• The firmware versions numbers.
• A list of installed or not-installed options:
– Page Description Language (PDL) board
– Coprocessor board
• The amount, in bytes, of total system and available memory. Total System
Memory is used to store downline loaded fonts and the data you are
printing.
• The page count number increments by one (1) for each printer sheet. Write
this number in the printer maintenance log.
2–16 Control Panel Operations and Menus