Digital Equipment DEClaser 320, Руководство по обслуживанию

Страница: 312 / 400

10.4 Vertical Registration Adjustment
10.4 Vertical Registration Adjustment
The vertical registration fixes the image between the leading and trailing
edges of the sheet. The vertical registration is perfect when the width of the
leading and trailing boarders are identical. Use the following procedure to
enter, change, and exit the Vertical Registration set menu:
1. Press and hold
Defaults
and
>
while powering up the printer.
2. When you see four zeros (0000), press the menu mode keys to set the 1701
code and press
3
once to enter it, as shown in Table 3–1.
3. Press the menu mode keys to set the 0282 code and press
3
to enter it.
4. Press the menu mode keys to set 0282.02 code.
5. Press
3
to enter the code. The current setting, or default, is displayed.
The following example demonstrates the Vertical Registration set menu
format:
$0A:
#
0.9mm
$ A dollar sign acts as a prompt.
0A The two digit hexadecimal set code. The higher order digit (0) is
always zero and it cannot be altered. The lower order digit (A) changes
the offset display.
: A colon separates the set code from the offset display.
#
Arrows indicate the direction of image offset from the dead center of
the sheet. Down is toward the trailing edge, up is toward the leading
edge.
0.9mm The amount of offset shift for the accompanying set code. The following
settings are available:
$00:
"
3.6mm $08: 0.0mm Recommended factory default.
$01:
"
3.2mm $09:
#
0.5mm
$02:
"
2.7mm $0A:
#
0.9mm
$03:
"
2.3mm $0B:
#
1.4mm
$04:
"
1.8mm $0C:
#
1.8mm
$05:
"
1.4mm $0D:
#
2.3mm
$06:
"
0.9mm $0E:
#
2.7mm
$07:
"
0.5mm $0F:
#
3.2mm
6. Press
^
and
_
to change the lower order set code and change the image
position.
7. Press
3
to enter the new position.
8. Press
>
and
Defaults
to exit from the Vertical Registration set menu.
The four zeros (0000) will reappear.
10–4 Adjustments and Cleaning Procedures