Digital Equipment DEClaser 320, Руководство по обслуживанию

Страница: 16 / 400

About This Service Guide
The following table describes the DEClaser 3200 Printer Service Guide:
Section Comments
Chapter 1 Provides physical and functional descriptions of the printer and the
cassettes.
Chapter 2 Describes the control panel operation and customer-accessible menus, test
patterns, and printouts.
Chapter 3 Describes service-accessible menus; the test patterns and printouts; and
the special functions and tests. The test codes enable you to operate any
discreet components (solenoid, clutch, sensor, and so on) thus verifying the
operability of each electrical circuit.
Chapter 4 Describes the overall and non-error-code troubleshooting. Section 4.1 is the
overall fault isolation procedure (Start FIP). By completing the start FIP,
you verify the correct operation of the printer or isolate a malfunction. The
Start FIP will direct you to other specific FIPS, described in Chapters 4, 5,
6, 7, and 10.
Chapter 5 Interprets the display panel error codes and gives a FIP for all but the
paper jam codes.
Chapter 6 Describes the paper jam FIPs.
Chapter 7 Describes the image defect and print quality FIPs.
Chapter 8 Contains the Recommended Parts List (RSL) and a section for finding the
location of a named part.
Chapter 9 Provides instructions on how to remove and replace the major assemblies
within the DEClaser 3200 printer.
Chapter 10 Defines the DEClaser 3200 adjustments and cleaning procedures.
Chapter 11 Describes the High Capacity Feeder (LCIT), which is optional equipment
for the DEClaser 3200 printer. This chapter also contains the nonerror
code LCIT FIPs and the LCIT removal and replacement procedures.
Appendix A Contains technical and functional information.
xvii