Digimerge DPP12D, Инструкция по эксплуатации

Страница: 8 / 22

Electronic Day/Night Professional Camera
13 12
Electronic Day/Night Professional Camera
■
Installation Installation
■
The camera is supplied without a lens. Lenses, such as auto iris,
CS-Mount and C-Mount, can be used.
1. Strip back about 8mm of the outer sheath of the auto iris lens cable.
2. Strip off about 2mm of the insulation of wires inside the
lens cable.
■ Lens
Note
ㆍ
Using a DC auto iris lens is recommended to achieve the best
possible results from the camera.
ㆍ
Please keep the lens clean.
ㆍ
Foreign objects or fingerprints on the lens will result in inferior image
quality, especially in low light level conditions.
Using the auto iris
3. Remove the cover of the auto iris lens connection plug and solder the
wires to the connector pins inside the plug, as shown below.
4. Replace the auto iris lens connection plug cover. Remove the lens
protection cap and then attach the auto iris lens to the camera by
screwing it in clockwise.
5. Insert the connection plug connected to the auto iris lens cable into
the auto lens connector jack, which is located on the rear of the camera.
6. Set the lens selection switch, located on
the rear of the camera, to either DC or VIDEO,
depending on the type of auto iris lens being
used.
Pin No.
LENS
DC VIDEO
Pin No.1 Damping Coil- Red (power)
Pin No.2 Damping Coil+ NC
Pin No.3 Drive+ White (video signal)
Pin No.4 Dreve- Black (GND)
IRIS JACK OSD EXTRA
POWER
DC
VIDEO
SET
VIDEO OUT
AC24V IN
DC12V IN