Serial port
Configure Remote Access mode
Digi Connect EZ Mini User Guide
91
l
Enable
full_duplex
if you want to enable full duplex communication on this serial
port:
(config)> serial port1 full_duplex true
(config)>
The default is
rs-232
.
7. (Optional) Set a label that will be used when referring to this port.
(config)>path-paramlabel
label
(config)>
8. Set the baud rate used by the device to which you want to connect:
(config)>path-parambaudrate
rate
(config)>
9. Set the number of data bits used by the device to which you want to connect:
(config)>path-paramdatabits
bits
(config)>
10. Set the type of parity used by the device to which you want to connect:
(config)>path-paramparity
parity
(config)>
Allowed values are:
n
even
n
odd
n
none
The default is
none
.
11. Set the stop bits used by the device to which you want to connect:
(config)>path-paramstopbits
bits
(config)>
12. Configure the session settings.
a. Set the characters used to start an escape sequence:
(config)>path-paramescape
string
(config)
If no characters are defined, the escape sequence is disabled. The default is
~b
.
b. Limit access to the serial port to a single active session:
(config)>path-paramexclusive true
(config)
c. Set the number of bytes of output from the serial port that are written to buffer. These
bytes are redisplayed when a user connects to the serial port.
