User authentication
Authentication groups
Digi Connect EZ Mini User Guide
415
5. Use the
show
command again to verify the change:
(config)> show auth method
0 radius
1 local
(config)>
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
Authentication groups
Authentication groups are used to assign access rights to Connect EZ users. Three types of access
rights can be assigned:
n
Admin access
: Users with Admin access can be configured to have either:
l
The ability to manage the Connect EZ device by using the WebUI or the Admin CLI.
l
Read-only access to the WebUI and Admin CLI.
n
Shell access
: Users with Shell access have the ability to access the shell when logging into the
Connect EZ via ssh, telnet, or the serial console.
Shell access is not available if the
Allow shell
parameter has been disabled. See
for more information about the
Allow shell
parameter.
n
Serial access
: Users with Serial access have the ability to log into the Connect EZ device by
using the serial console.
Preconfigured authentication groups
The Connect EZ device has two preconfigured authentication groups:
n
The
admin
group is configured by default to have full
Admin access
.
n
The
serial
group is configured by default to have
Serial access
.
The preconfigured authentication groups cannot be deleted, but the access rights defined for the
group are configurable.
This section contains the following topics:
Change the access rights for a predefined group
