Diagnostics
Perform a speedtest
Digi Connect EZ Mini User Guide
575
Perform a speedtest
To perform a speedtest:
Command line
1. Log into the Connect EZ command line as a user with Admin access.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
admin
to access the Admin CLI.
2. Use the
speedtest
command to generate the report:
> speedtest
host
where
host
is the hostname or IP address of a speedtest host. For example:
> speedtest speedtest.accns.com
Tx (upload) average: 50.1110 Mbps
Tx latency: 31.45 ms
Rx (download) average: 44.7588 Mbps
Rx latency: 30.05 ms
>
3. To output the result in json format, use the
output
parameter:
> speedtest
host
output json
{"tx_avg": "51.8510", "tx_avg_units": "Mbps", "tx_latency": "31.07",
"tx_latency_units": "ms", "rx_avg": "39.5770", "rx_avg_units": "Mbps",
"rx_latency": "34.19", "rx_latency_units": "ms" }
>
4. To change the size of the speedtest packet, use the
size
parameter:
> speedtest
host
size
int
5. By default, the speedtest uses nuttcp for the mode. You can change this to iperf with the
mode
parameter:
> speedtest
host
mode iperf
6. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
Generate a support report
To generate and download a support report:
WebUI
