Services
Enable service discovery (mDNS)
Digi Connect EZ Mini User Guide
346
Repeat this step to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the Connect EZ
device:
(config)> add service mdns acl interface end
value
(config)>
Where
value
is an interface defined on your device.
Display a list of available interfaces:
Use
... network interface ?
to display interface information:
Repeat this step to list additional interfaces.
n
To limit access based on firewall zones:
(config)> add service mdns acl zone end
value
Where
value
is a firewall zone defined on your device, or the
any
keyword.
Display a list of available firewall zones:
Type
... firewall zone ?
at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Repeat this step to list additional firewall zones.
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
