Serial port
Configure Modbus mode
Digi Connect EZ Mini User Guide
111
(config)> serial port1 "rts_pre_delay
value
(config)>
l
For
rts_post_delay
, enter the amount of time RTS is deasserted before completing
data transmission. The time is measured in milliseconds. The default is
0ms
:
(config)> serial port1 rts_post_delay
value
(config)>
n
rs-422
l
Enable
Termination
if you want to enable electrical termination on this serial port.
n
rs-485
l
Enable
termination
if you want to enable electrical termination on this serial port:
(config)> serial port1 termination true
(config)>
l
Enable
full_duplex
if you want to enable full duplex communication on this serial
port:
(config)> serial port1 full_duplex true
(config)>
The default is
rs-232
.
7. (Optional) Set a label that will be used when referring to this port.
(config)>path-paramlabel
label
(config)>
8. Expand
Serial Settings
.
The entries in the following fields must match the information for the power controller. Refer
to your power controller manual for the correct entries.
a.
Baud rate
: For
Baud rate
, select the baud rate used by the device to which you want to
connect. The default is
9600
.
b.
Data bits
: For
Data bits
, select the number of data bits used by the device to which you
want to connect. The default is
8
.
c.
Parity
: For
Parity
, select the type of parity used by the device to which you want to
connect. The default is
None
.
d.
Stop bits
: For
Stop bits
, select the number of stop bits used by the device to which you
want to connect. The default is
1
.
e.
Flow control
: For
Flow control
, select the type of flow control used by the device to
which you want to connect. The default is
None
.
1. Set the baud rate used by the device to which you want to connect:
(config)>path-parambaudrate
rate
(config)>
