14
12. CONTROLLER
12.1 CONTROLLER OPERATION
Communication between the remote and the
controller is established in this mode.
Turn the selector to CONTROLLER
position
The opening screen displays the available
options:
New
Enter a new controller name into the system, set an ID No. and a name
Load
Load a program from the memory
Rename
Change the name of the controller (ID cannot be changed)
Receive
Read a program from a controller
Clear
Erase the current editor
Delete
Delete the controller and memory from the system
Send
Send a program to a controller and save in memory
Status
Read the status of a controller
Press
to bring the cursor to the desired operation. Use
to select the operation. The screen
changes accordingly.
12.2 NEW CONTROLLER ADDED TO SYSTEM
When you add a new controller to the system or during the initial stage, when the system is still
empty, give names to the different controllers, according to the ID numbers of the controllers.
Turn the selector to CONTROLLER
position
Press
until the cursor appears below the
word New. Press
, the screen changes.
Press
. The cursor appears below the left
digit of the ID line. Use
,
and
to copy
the ID number that is displayed on the body
of the controller. This ID number is imprinted on the controller and cannot be
changed.
Press
. The cursor appears to the left of Name. Use
,
and
to give
a name to the controller for your convenience. Press
until the cursor is
below the required mode Save, Cancel or Clear.
Press
to select the required mode and wait for confirmation:
Save
Saves the name
Cancel
Does not save
Clear
Clears the current name
At this stage, you can send the program to the controller, refer to page 16
15
12.3 CLEAR OR ERASE PROGRAM
Used to erase the program you are editing.
Turn the selector to CONTROLLER
position
NOTE: Clear erases complete program
from the editor.
Press
until the cursor appears below the
word Clear. Press
, the screen changes. Use
to indicate if you wish to
delete or not. Press
to receive confirmation of the delete.
12.4 LOAD PROGRAMS FROM CONTROLLER
Used to read or review a program of a chosen
controller, when you are not near the
controller. You can read the program from the
memory of the Remote.
Turn the selector to CONTROLLER
position
Press
until the cursor appears below the
word Load. Press
, the screen changes.
Use
or
to select the ID and name of the
controller you wish to read. Press
.
Upon receiving confirmation:
program was transferred to the editor and you can review and read it.
12.5 DELETE CONTROLLER FROM SYSTEM
Used to delete a chosen controller from the system.
Turn the selector to CONTROLLER
position
Press
until the cursor appears below the
word Delete. Press
, the screen changes.
Use
or
to select the ID and name of the
controller you wish to erase. Press
. Upon
receiving confirmation, the controller is
deleted.
The controller does not exist in the system nor in the memory of the
remote.