18
13. HOME FILES
In this mode you can save up to 4 files
(programs) in the memory of the remote. You
can retrieve these files (Home Files) from the
memory and send them to the controllers at
any time you wish.
Save to File
– Transfers a file from the editor
to Home Files.
Load to Edit
– Transfers one of the Home Files to the editor.
Change File Name
– Changes the name of a file, for your convenience.
Turn the selector to HOME FILES position
Change File Name – Sets and changes the name of a chosen file in Home
Files.
Press
to select a file. Use
,
and
to enter a name for the file, for your convenience. Use
or
to move to Save. Press
and wait for: Successful. The name was set.
You can change the name of the file at your convenience by following the steps on this page.
13.1 SAVE TO FILE
Turn the selector to HOME FILES
position
Use this mode to save a chosen file, that is in
the editor, in one of the Home Files, under a
chosen Name.
Press
until the cursor appears under the
words Save to File. Press
until you reach
the place where you wish to save the file.
Press
and wait for: Save Successful. The file is saved. The screen returns
to the main menu.
13.2 LOAD TO EDIT
Turn the selector to HOME FILES
position
Load to Edit – Retrieves a program out of a
Home File to the remote for entering changes
or review. A program saved in a Home File is
a program you prepared in advance which
does not reside in any of the controllers or
the memory.
Press
until the cursor appears under the words Load into Editor.
4 files names are displayed. Press
to select the desired file.
Press
. Approval of successful loading is displayed in the bottom line. The screen returns to the
main menu. The program is residing in the editor for review/change or for sending to a chosen
controller.
19
14. SUMMARY – PROGRAMMING THE SYSTEM
Summary of Operations
1. Initial programming and sending program to a controller in the field
a. Program the controller in the remote (editor)
b. Access controller mode using the selector
c. Select send mode
d. Execute send command to a chosen controller
e. Receive confirmation. Program sent to the controller and saved in the memory of the Remote
2. Read a program from the controller in the field for test and change
a. Access controller mode using the selector
b. Select receive mode
c. Execute receive command
d. Receive confirmation. Program transferred from the controller to the Remote for test or change
3. Read program from memory for testing
a. Access controller mode using the selector
b. Access load mode.
c. Execute load command. The program resides in the editor
4. Reading the Controller Status
a. Use the selector to access controller mode
b. Access status
c. Reach status command
d. Receive confirmation. If the command fails, repeat the request
e. Read status
5. Manual Operation
a. Access manual mode using the selector
b. Select controller, name and ID
c. Select desired type of operation
d. Press send to implement the command and receive confirmation
6. Save in Home File
a. Full programming of a controller according to a defined program
b. Access home file mode using the selector
c. Access save to file mode
d. Access files table and select a file
e. Save the program in the file
7. Load a program from Home Files to the Editor
a. Access home files using the selector
b. Access load to edit
c. Access files table and select a file
d. Receive confirmation. The program resides in the editor
