Tonometric unit - wTn1
1. On / Off button: keep pressed for about 1 sec.
2. Cap for battery replacement: pull away from the tonometer’s body. Remove the old battery pushing it
from the side opposite the opening. Insert the new battery without ever forcing and respecting the
polarity indicated by the appropriate label. Put the cap back in its seat by pushing it until clicks.
3. Active part of the tonometric sensor.
ECG unit - wEc1
1. On / Off button: keep pressed for about 1 sec.
2. Cap for battery replacement: pull away from the unit’s body. Remove the old battery. Insert the new
battery without ever forcing and respecting the polarity indicated by the appropriate label. Put the cap
back in its seat by pushing it until clicks.
3. Patient cable sockets.
Signal Receiver unit - wRs1
1. Operating mode signaling LED. This LED blinks green when the PulsePen software is not running or if
the USB driver is not properly installed. The LED is solid green during normal operations while it is red
during reprogramming / updating.
7
User Manual
PulsePen
- V. 5.0_b
