wRs1
CV010
Computer
(recommended configuration)
Computer Connection
The connection of the WPP001-ET / WPP001-ETT device to the computer
is done through the wRS1 unit, by inserting it into a USB 1.0 / 2.0 - type A port:
Software Installation
The PulsePen system includes two software (x.x.x means the version):
• WPulsePen (WPP001-ETT- x.x.x): full-featured software for the capture, display, storage, and analysis of
signals with the calculation of the parameters. It includes the patient database management and works
on signals up to 10 ECG/ tonometric complexes. It’s also possible to make long-term signal records (see
the online Help). This software allows for the generation of a patient report, the content of which must
always be verified by a physician expert in the method. DiaTecne s.r.l. takes no responsibility for the final
diagnosis.
• WPulsePen-LP (WPP001 LP-ETT- x.x.x): software for capturing, displaying and saving long-term signals. It
does not perform signal analysis or patient database management.
To install the software included in the supplied USB drive, proceed by following the instructions given in
the “readme.txt” file: both the WPulsePen and WPulsePen_LP software will be installed, with their icons
on the desktop and the USB drivers for the wRs1 receiver. Refer to "Usage Problems and Solutions" if you
have difficulty.
The “Arial” font should be installed on the computer for a correct representation of the text.
PC connection
USB 1.0 / 2.0 - type A
Data transmission
Wireless, ISM @ 2.4 GHz
LED
Operating mode signaling
Power supply
< 50 mA @ 5V, powered by the USB connector of the P.C.
Weight
12 g
Dimensions [mm]
67 (L) x 25 (W) x 11 (H)
Terminals
Universal for tab, clip, press-stud ECG electrodes
Connettors
DIN 42802 compliant
Clock Frequency
≥ 2GHz
Ram
≥ 2 GB
Free Hard Disk space
≥ 4.5 GB (SW + Database)
Graphic Resolution
≥ 1280 x 800, 24 bit color
Operating System
Windows® XP SP2/3, Vista, 7, 8, 10 - 32/64 bit
USB ports
≥ 1
Safety
EN 60950-1 and later compliant
9
User Manual
PulsePen
- V. 5.0_b
