Dhollandia DH-RP.10, Руководство по установке, Страница: 29 / 76

28
DHOLLANDIA
Figure 10.2
The mounting plates MUST be bolted to the vehicle chassis, the bolts and nuts tightened with the required torque,
according to the instructions below and on right side.

Pay special attention to the type, minimum quantity, minimum size and strength, position and prescribed torque. [Figure 10.3]
 The mounting plates are bolted to the vehicle chassis with min. 6 bolts M14 per side, supplied with the lift, spread over the widest
possible surface to maximize the strength of the bolted connection. Fasten the 6 bolts M14 per side with the required torque
.
[
Figure 10.3
]
Per side
2x M24x2 (10.9) hand tightened 185Nm
WARNING

Incorrect installation of the mounting plates and bolts can lead to accidental fall of the tail lift off the vehicle chassis.

A fall of the tail lift off the chassis can damage the tail lift and / or vehicle chassis and can cause serious bodily injury or death
to the operator and any bystanders.

Therefore, it is essential that the mounting plates are installed following the instructions of this manual.
❶
❶