Dhollandia DH-RP.10, Руководство по установке, Страница: 30 / 76

29
DHOLLANDIA
Figure 10.3
Figure 10.4

Alternatively, the mounting plates may be welded to the chassis rails instead of bolted. When doing so, observe the precautions
regarding welding on galvanized steel on page 22.

Make min. 6 pcs. 10mm welds, min. 102mm long, evenly spread around the periphery of the mounting plates (per plate). [Figure
10.5]

When there is an overlap between the mounting plates and the long sills, make min. 2 pcs. 10mm welds, min. 102mm long, at the
top of the mounting plates (per plate). [Figure 10.5]

If there is no overlap, add a connection plate to extend the height of the mounting plate, overlap the long sills, and make min. 2
pcs. 10mm welds, min. 102mm long, at the top of the mounting plates (per plate). Apply equivalent welds to join the mounting
plate with the connection plate. [Figure 10.6]
Per side
Min. 6x M14x1.5 (10.9) 185 Nm
Per side
Extra 2x M14 (10.9) 185 Nm

Check if the long sills, the body cross members and
floor are securely attached to the chassis and will
form one solid construction once weight will be
applied on the platform. If not, attach the mounting
plates of the tail lift to the long sills on top of the
chassis by means of 2 additional bolts M14 per side,
or equivalent. [Figure 10.4]. Fasten these bolts with
the required torque.