Troubleshooting
The Image Is Uneven.
Is the imprint surface slightly
uneven? / Is the imprint sur
-
face at an angle?
Attach a head cap and perform imprinting. If you’re using material
that can be damaged by imprinting with the head cap attached,
then replace the material with one that has a level imprint surface.
P. 61 "Precautions for use of head cap"
Is the image darkness uneven?
Performing overstriking may improve the image quality. With the
material left loaded, try performing overstriking with different
settings for [Gamma], [Brightness], or [Contrast] in the preview
window.
P. 88 "Checking and Adjusting Finished Result of an Image"
Was bidirectional imprinting
performed?
Bidirectional imprinting can shorten the imprint time, but the
image quality may suffer. If this happens, go to the METAZA Driver
2 setting window and clear the selection for [Bidirection], then
perform imprinting again.
METAZA Driver 2 online help (“[Material] tab”)
Is the marking pin worn?
Attractive imprinting may be impossible if the marking pin be-
comes worn. Check the state of the marking pin. If the marking
pin becomes worn, replace the head with a new one.
Is the head cap worn?
Attractive imprinting may be impossible if the head cap becomes
worn. Check the state of the head cap. If the head cap is worn,
replace the head cap with a new one.
4
Trouble
-
shooting
122
