Replacing Consumable Parts
MEMO
The indicator for [The amount of Pin usage] in MPX-95 Head Manager shows how much the marking
pin has been used. The head should be replaced in the following cases.
• The indicator is shown in red.
• Although the indicator is not shown in red, attractive imprinting is impossible or images are uneven.
A worn-out marking pin is not the only reason for decreased imprint quality and uneven imprint
results. Refer to the following pages to find the cause of the problem. If wear on the marking pin
can be the cause of the problem, replace the head with a new one.
"
P.121 "The Imprinted Image Is Unattractive."
"
How to Replace the Head
MPX-95 Head Manager is used for replacing the head. The pattern shown in the figure is struck during the
head replacement operation. You need to prepare a test imprint material (brass), which is supplied with a
replacement head (MPH-90), or a material equal to or larger than 60 mm (2.4 in.) wide by 60 mm (2.4 in.) long.
* Replacement heads are sold separately. For purchasing information, contact your authorized Roland
DG Corporation dealer or visit our website (http://www.dgshape.com/).
Adjustment pattern
IMPORTANT
• Do not stop the replacement operation halfway.
• Do not use the head if the marking pin is worn out.
• Do not use a head that has been detached from the machine.
Procedure
A
Start MPX-95 Head Manager.
"
P.28 "How to Start The Software"
B
Switch on the power to the machine.
"
3
Maintenance and
Adjustment
115
