DFC NSV-400, Руководство по эксплуатации и технические характеристики

Страница: 8 / 26

9
15000

Feed Speed
The following menu will prompt
when ‘

’ button is pressed
Press the necessary digits /
buttons, for example if
‘13000’ were pressed, it will
be displayed in the dashed
box (i.e.//////////)
Press ENT to enter the
number when finished.
Step 6: Enter the password to set the setting.
Example: To change ‘Feed Speed’ press ‘

’ as shown:
Step 7: Repeat above examples to all parameters settings if necessary.
Step 8: Press MANUAL ADJUST to return to MANUAL ADJUST 1, and then press
AUTO MODE to go to AUTOMATIC MODE MENU; or press PARAMETER
ADJUST to go back to setup parameter again.
Step 9: Press AUTO ON to start the machine.
1.4.4 F
EED
C
UT
H
EAD

Material is fed by two rubber rollers driving against a set of bearings on the mandrel.

The roller is servo controlled. The standard method of controlling the material cut length is
via servo controller fitted to the drive roller axis. The signal from the encoder is monitored
by the cut length indicator/controller in the control enclosure. The controller is interfaced
with a P.L.C which discontinues the feed at the pre-selected feed length value.

An alternative method of feed length control is photo registration commonly used on printed
materials.

Maximum feed length – please refer to the original specification.

Material is cut to length by cutting unit, which contains 6 rotating blades.
7
.
7
8
CLR
9
4
5 6
ESC
2 3
0
-
7
ENT
DEL
4
1