Deutz EMR 2, Описание системы, Страница: 27 / 60

© 06/02
Page 85
EMR 2
Configuration and
Parameter Setting
1
2
3
4
5
6
7
8
9
10
11
12
13
6 Configuration and Parameter Setting
The EMR 2 is specially programmed and configured for each individual engine, which means that the
EMR 2 contains a specially engine-specific data set. Configuration is carried out via the externally accessi-
ble diagnostic interface (ISO 9141) and is strongly dependent on the customer’s wishes, from the applica-
tion cases and from the behaviour of a vehicle in operation.
Access to the various parameters is protected (by password) by means of access authorizations organized
on four levels and can only be carried out by authorized personnel.
More than 1200 different parameters are available. Access to these parameters, as well as to other data,
can be carried out by means of the special SERDIA diagnostic software installed on a PC (see Chapter
7.3).
☞
Important!
Rebuilding, as well as alteration to the parameters can only be carried out in conjunction with
the corresponding DEUTZ operating partners. For this purpose SERDIA Level III is required.
In connection with the above-mentioned possibilities, the changed data sets must be repor-
ted back to DEUTZ (see Service Note No. 0199-99-9287).
Type of operation
e.g. parallel opera-
tion
Scope of function
Switching
diagrams
Other type of
operation
desired
Part data set
Performance
dataset
Complete data set
see “SERDIA” handbook
Notification
to DEUTZ
see “SM 0199-99-9287”
Re-blocking
!
Other set speed
!
Other performance
!
Other set speed and
other performance
Other
performance data
desired
© 06/02