49
CL3
Series
4.0
Operation
•
Operating Instructions
4.0
Operation
WARNING
!
BEFORE OPERATING
, smell all around the appliance area for gas. Be sure to smell next to the floor as
some gas is heavier than air and will settle to the floor. Refer to page 1 “If you smell gas” and on safety
label affixed to the heater.
Do not
use this appliance if any part has been under water. Immediately call a qualified service
technician to inspect the appliance and to replace any part of the control system and any gas control
which has been under water.
Operating Instructions
This appliance does not have a pilot ignition. It is equipped with an ignition device which
automatically lights the burner.
Do not
attempt to light the system by hand.
Lighting Procedures:
1
STOP!
Read the safety information above.
2
Set the thermostat to the lowest setting.
3
Turn OFF all electrical power to the appliance.
4
Turn manual shutoff clockwise to “OFF”.
5
Wait 5 minutes to clear out any gas. If you smell gas STOP! Follow the safety information
found on page 1 “If you smell gas” and on safety label affixed to the heater. If you do not smell gas,
proceed to step 6.
6
Turn manual shutoff knob counterclockwise to “ON”.
7
Turn ON all electrical power to the appliance.
8
Set thermostat to desired setting.
9
If the appliance will not operate, follow instructions below to turn OFF gas to the appliance and call
your service technician or gas supplier.
Shutdown Procedures:
1
Set the thermostat to the lowest setting.
2
Turn OFF all electrical power to the appliance if service is to be performed.
3
Turn manual shutoff knob clockwise to “OFF”.
Do not
force.
WARNING
!
Use only your hand to turn the manual shutoff. Never use tools. If the
knob will not turn by hand, don’t try to repair it; call a qualified technician.
Force or attempted repair may result in a fire or explosion.
