Deprag AST11-1, Руководство по эксплуатации

Страница: 46 / 122

46
8.2.5.5 Menu Test
8.2.5.5.1 Tool Test
8.2.5.5.1.1 Speed Test
The mode “speed test” allows the testing of the speed outside of the program sequence.
The two function keys can control the speed test.
Proceed as follows:
• input nominal speed:
• use left function key „Nominal Value“; a blinking Cursor occurs
• input nominal speed and confirm entry with the ENTER key
• To run driver, use right function key “START“; Driver rotates at specified speed
• To stop driver, use right function key “STOP“; Driver stops
Exit the menu item „Speed Test“ with the ESC-key.
8.2.5.5.1.2 Angle Test
To verify the angle measurement, simply rotate the screwdriver. The current angle is dis-
played. Use the right function key “RESET” to reset the angle value to “0”. Exit the menu
item „Angle Test“ with the ESC-key.
8.2.5.5.1.3 Torque Test
The menu item “Torque Test” allows the verification of the torque measurement, even out-
side of program sequences. A one-step standard program will be created using the input
torque value, which in turn can be verified through a tightening process on a measuring
platform. The two function keys may control the torque test.
Proceed as follows:
• Insert the nominal torque:
• Press the left function key “Nominal Value”; a blinking Cursor occurs.
• Input nominal torque and confirm entry with the ENTER-key.
To activate the driver, press the function key “START”; the driver starts the tightening pro-
gram.
Press the STOP-key to turn the driver off.
To exit the torque-test menu at any time, simply press the ESC-key.