Deprag AST11-1, Руководство по эксплуатации, Страница: 44 / 122

44
8.2.5.3.6.9 Default Values
Use this menu area to reset the setup-adjustments of the sequence controller to the origi-
nal values (see
10.2 Default Values ).
8.2.5.3.6.10 Maintenance Interval
In this menu the maintenance intervals can be set (see also 10.1.1 Parameters of the Sys-
tem Settings ). The maintenance intervals can only be entered in steps of thousands.
To change the value, proceed as follows:
• Use the left function key “Modify?”
• input value
• confirm entry with ENTER-key.
Use the right function key “SET?” to save your entry.
8.2.5.3.6.11 F-Function (only visible with handheld Screwdrivers)
see separate chapter 9 F-Function
8.2.5.3.6.12 Program Choice
Here you can set the mode for program choice (see also 10.1.1 Parameters of the System
Settings ).
If “fixed setting” is selected then in the following menu item (PG-Setting) a value for the
program number can be entered.
To select the between the signal options, use the cursor keys. Confirm your entry with the
Enter key. Use the ESC-key to exit this menu without making any changes.
8.2.5.3.6.13 PG-Setting (only visible with handheld Screwdrivers)
If “fixed setting” (previous menu item “Program Choice”) is selected then in this menu item
a value for the program number can be entered.
To change the value, proceed as follows:
• Use the left function key “Modify?”
• input value
• confirm entry with ENTER-key.
Use the right function key “SET?” to save your entry.