85
Reload
Functionality for the control of screw feeders directly via the
sequence control
Profibus
Industriebus for the control and data exchange with sequence
control.
Profinet
Industriebus for the control and data exchange with sequence
control resp. the base station
Program selection
Selection of the program to be started. The program selection
can occur in different ways, depending on control and
selected screw types (e.g. E/A interface at the control, direct
program switching at the screwdriver, etc.)
Ready signal
The ready signal indicates that the control is ready for the
start of a screwing application. If the ready signal is not
available then either a screwing application is active or a state
is present that prevents the screwing application (certain
menus, system error).
Resolver
electro-magnetic transducer to change the angle position of a
rotor in an electric size
Screwing sequence
Sequence of the screwing process
Consists of commands and screwing samples
Screw driver logic
Electronic where all data of the screwdriver is stored. If the
screwdriver is connected to the controller then it recognizes
all data of the screwdriver. No settings have to be performed
manually.
Screwing sample
Implementation of common screwing processes with pre-
defined parameters which contain the correct value of a
screwing application. (e.g. screwing application on torque with
rotational angle control)
Screwing program
Sequence of the screwing process
Consists of commands and screwing samples
Standard deviations
mean deviation of measuring values from the mean value.
1
1
2
n
x
x
s
n
i
i
Clearance for start
If the clearance for start is activated then the screwdriver will
only start if there are 24V at the clearance to start input.
Otherwise the controller is not ready to screw.
Starting via buttons
The screwdriver starts as soon as a button on the screwdriver
is actuated.
Toolbox
Accessories for the automatic selection of a certain screwing
program based on the used tools.
Monitoring criteria
Criteria that will lead to abort the screwing program even
though the switching off criteria has not yet been reached
(e.g. Time monitoring, angle monitoring during torque
screwing applications).
