PROCEDURE AFTER REPLACING THE MICROPROCESSOR, ETC.
The procedure after replacing the u-COM (microprocessor), flash ROM, etc. is as follows.
PCBnName
Ref.nNo.
Description
Proce-
durenaftern
Replace-
ment
Remark
(MAIN)
IC28
R5F56108VNFP
B
-
CN66
CN67
CY920 MODULE ASSY
B
SOFTWARE: SYSTEM
Be sure to replace the NFC module at the same
time.
Procedure after Replacement
An:
The software has been written. The software is not written at the time of replacement.
Bn:
The software has been written. The software may need to be rewritten by version updates. Check the version.
Cn:
The software has not been written. The software needs to be written after replacement.
See "
FirmwarenUpdatenProcedure
" for information on writing the software.
Dn:
The software has been written. Be sure to rewrite with the latest software for your service region.
See "
FirmwarenUpdatenProcedure
" for information on writing the software.
FIRMWARE UPDATE PROCEDURE
1. Updating by USB
The latest firmware can be downloaded to a USB memory for updates.
1.1. Connecting to the USB Memory
(1) Preparation
•
USB format : Prepare a USB memory formatted in FAT16 or FAT32.
•
Do not run the USB memory through a hub.
•
Do not connect a computer to the USB port of this unit using a USB cable.
•
Do not use an extension cable when connecting the USB unit.
1.2. Unzip Download File
Unzip the downloaded file on your computer.
RCD-XXXXXXX
USB_RCD-XXXXXXX_XXXXXXXXXXXX-XXXX.zip
You can find "
firmwares
" folder after unzipped.
Copy that folder to USB flash drive.
You have to put "
firmwares
" folder on root directly on USB flash drive(memory).
copy to USB flash drive
31
Содержание CEOL RCD-N9
Страница 34: ...Personal notes 34 ...
Страница 45: ...Personal notes 45 ...
Страница 77: ...TC7USB40MU NETWORK IC62 TC7USB40MU Block Diagram 77 ...