RDM Network Scanner User Guide
Setting up your scanner
©2021 RDM Corporation
Page 20
Connecting the power cord
1.
Align the flat side of the power connector so that it is facing up.
2.
Insert the round end of the power cord into the power port on the back of the
scanner until it clicks into place.
Note: Although the status light on the scanner might illuminate without the power
cord being fully connected to the scanner,
you must push the power cord until it
clicks into place for the scanner to function correctly.
3.
With the power cord connected to the power adapter, plug
the other end of cord into an electrical outlet.
4.
If your power cord has an on/off switch, make sure the
s
witch is in the “on” position.
How to connect your EC9600i Network Auto Feed check scanner
How to connect your EC9600i Network Single Feed check scanner
Alternatively visit:
https://www.youtube.com/user/RDMCorporation/playlists
Disconnecting the power cord
Caution:
Disconnecting the scanner from a power source while the scanner is processing a transaction
might cause data loss.
The power cord has a sleeve on it that secures it to the unit. The security sleeve prevents the power
cord from being pulled out of the unit accidently.
1.
Hold the unit in place with one hand to prevent the unit from falling.
2.
With your other hand, slide the power cord security sleeve back and pull the power cord free of
the scanner.
Installing cartridges and paper roll
For installing the franker cartridge, see
Installing the franker cartridge on page 30
For installing the endorser inkjet cartridge, see
Installing the endorser inkjet cartridge on page 31
For installing the paper roll, see
Replacing the paper roll for the
on page 32.
