DeltaOHM HD2010UC/A, Руководство по эксплуатации

Страница: 92 / 162

HD2010UC/A
- 92 -
V4.1
6. When the message “Formatting completed” appears, press OK for confirmation and CLOSE
to exit.
7. Close the Noise Studio software.
8. The formatting has been accomplished and the card is ready for use.
C
ONNECTION OF
HD2010MC
TO THE SOUND LEVEL METER AND USE OF THE MEMORY CARD
Connection of the HD2010MC:
1. Switch off the sound level meter .
2. Connect HD2010MC to the M12 connector of the sound level meter ensuring the correct fas-
tening of the connector’s ring nut.
While inserting, please make sure that the arrow printed
on the reader is turned upwards. The reader has to be connected to the sound level meter in
vertical position.
3. Insert the memory card in the slot of HD2010MC interface.
4. Switch on the sound level meter and set the menu item “MENU >> Instrument >> Input/Output
>> Serial device ” on “MC”.
5. The sound level meter identifies the device. The display of the sound level meter shows “MC
connected” and the remaining dimension of memory. The LED on the card reader signalizes
the connection.
6. If the display visualizes “Connection failed”, check carefully if the memory card has been in-
troduced correctly into the slot and if the connector is plugged in properly.
When HD2010MC interface is connected to the sound level meter, any recording is automati-
cally sent to the memory card rather than to the internal memory of the sound
level meter.
During recording, the LED on the reader flashes upon receipt of every data package.
When memory is used up entirely, the recording will be interrupted.
To disconnect HD2010MC interface from the sound level meter:
1. Switch off the sound level meter.
2. Disconnect HD2010MC interface.
NOTE: Slipping off the memory card while the sound level meter is running and interface is
connected causes the loss of all data.
In order to replace the memory card, switch off the sound level meter.