DeLonghi ETAM29.62X, Инструкция по эксплуатации

Страница: 21 / 23

20
18. DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
FILL TANK Insufficient water in the tank (A20). Fill the tank with water and/or insert it correct-
ly, pushing it as far as it will go until it clicks
into place.
EMPTY GROUNDS CONTAINER The grounds container (A15) is full. Empty the grounds container and drip tray
(A14), clean and replace. Important: when
removing the drip tray, the grounds contain-
er must be emptied, even if it contains few
grounds. If this is not done, when you make the
next coffees, the grounds container may fill up
more than expected and clog the machine.
GROUND TOO FINE ADJUST
MILL The grinding is too fine and the coffee is deliv-
ered too slowly or not at all. Repeat coffee delivery and turn the grind-
ing adjustment dial (A23) (fig. 11) one click
clockwise towards 7 while the coffee mill is
in operation. If after making at least 2 coffees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click until delivery is correct (see
section “9.4 Adjusting the coffee mill”). If the
problem persists, make sure the water tank
(A20) is fully inserted.
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery. Deliver a little water until the flow becomes
regular.
INSERT GROUNDS CONTAINER After cleaning, the grounds container (A15) has
not been replaced.
Remove the drip tray (A14) and insert the
grounds container.
ADD PRE-GROUND COFFEE
The "pre-ground coffee" function has been se-
lected without placing any pre-ground coffee
in the funnel (A4). Place pre-ground coffee in the funnel (A4) or
deselect the pre-ground function.
DESCALE The machine must be descaled. The descaling procedure described in section
“13. Descaling” needs to be performed.
LESS COFFEE Too much coffee has been used.
Select a milder taste by pressing the
icon (B4) (fig. 8) or reduce the quantity of pre-
ground coffee.
FILL BEANS CONTAINER The coffee beans have run out. Fill the beans container (A3) (fig. 12).
The pre-ground coffee funnel (A4) is clogged. Empty the funnel with the help of the brush
(C5) as described in section “12.8 Cleaning the
pre-ground coffee funnel”.
INSERT INFUSER ASSEMBLY The infuser (A19) has not been replaced after
cleaning. Insert the infuser as described in section ““12.9
Cleaning the infuser”.
GENERAL ALARM The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly,
as described in section “13. Descaling”. If the
message is still displayed after cleaning, con-
tact a service centre.
WATER CIRCUIT EMPTY FILL
WATER CIRCUIT
HOT WATER
Press OK The water circuit is empty. Press OK (B1) and deliver water from the cap-
puccino maker (A8) until it flows out normally.
If the problem persists, make sure the water
tank (A20) is fully inserted.
REPLACE FILTER The water softener filter (C4) is exhausted. Replace the filter or remove it as described
in section “15. Water softener filter (*certain
models only)”.